Predicting of Parameters Affecting on PE Wax Powder Size Distribution and Shape in Atomization Process

https://doi.org/10.22146/ajche.49726

Ubonwan Madua(1*), Kulchanat Prasertsit(2), Paiboon Innachitra(3), Tanakorn Keatkhunboot(4)

(1) Department of Chemical Engineering, Faculty of Engineering, Prince of Songkla University, Hat Yai, Songkhla 90112
(2) Department of Chemical Engineering, Faculty of Engineering, Prince of Songkla University, Hat Yai, Songkhla 90112
(3) Department of Chemical Engineering, Faculty of Engineering, Prince of Songkla University, Hat Yai, Songkhla 90112
(4) Department of Chemical Engineering, Faculty of Engineering, Prince of Songkla University, Hat Yai, Songkhla 90112
(*) Corresponding Author

Abstract


The aim of this work is to study the parameters affecting on the particle size distribution and shape of Polyethylene wax (PE wax) powders in atomization process. Effect of liquid flow rate, melting temperature and air pressure are studied parameters. External mixing two fluid nozzles is used and temperature is controlled at 200˚C to avoid freeze-up within the liquid cap. PE wax is melted at various temperatures from 120˚C to 180˚C and is atomized with air pressures from 1 to 7 bar. Particle size and size distribution are determined by Particle Sizing Unified System (Mastersizer, 2000). Using 1 bar of air pressure, 140˚C of melting temperature and 3.0:1.5 of ALR gives the PE wax powders size that smaller than 200 micron and high bulk density. Moreover, smoothly and silky surface of PE wax powders are obtained.

Full Text:

PDF


References

1. Otaigbe, J.U. and J.M. McAvoy. (1998).Gas atomization of polymers. I. Feasibility studies and process development. Advances in Polymer Technology, 17(2): p. 145-160.
2. Wiwax. LTD. (2011). PE wax applications. Available from: http://www/wiwax.eu/en/main.php?k0 =APPLICATIONS. Accessed June 2011.
3. Sh-jiyuan Ltd. (2011). Spray drying manual. Avairable from: http://www.sh- jiyuan.com/download/01/SDX_MANUA L.PDF. Accessed June 2011.

4. Ejim, C.E., Rahman, M.A., Amirfazli, A. and Bleck, B.A.( 2010). Effects of liquid viscosity and surface tension on atomization in two-phase, gas/liquid fluid coker nozzles. Fuel. 89(8): p. 1872- 1882.



DOI: https://doi.org/10.22146/ajche.49726

Article Metrics

Abstract views : 1540 | views : 1891

Refbacks

  • There are currently no refbacks.


ASEAN Journal of Chemical Engineering  (print ISSN 1655-4418; online ISSN 2655-5409) is published by Chemical Engineering Department, Faculty of Engineering, Universitas Gadjah Mada.