Sistem Deteksi Bentuk Kecacatan Benda Padat Menggunakan Teknik Variasi Sudut Ultrasonik

https://doi.org/10.22146/ijeis.10773

Taufiq Nur Syahril Sidiq(1*), Abdul Rouf(2), Tri Wahyu Supardi(3)

(1) 
(2) Department of Computer Science and Electronics, Universitas Gadjah Mada
(3) Department of Computer Science and Electronics, Universitas Gadjah Mada
(*) Corresponding Author

Abstract


Making solid material frequent problems of  internal defect. This research intends to make a system to detect the form of defect in solid materials using ultrasonic waves. Components that was used in the system is a generator function, an op-amp,  ultrasonic sensor, oscilloscope and cylindrical solid material The method that used is reflected method of ultrasonic. Ultrasonic waves emitted from the transmitter to a solid material and the receiver will read a results of the reflection that occurs due to differences in medium objects. Oscilloscope will read of ultrasonic. Recitation will be done to determine the form of any cylindrical solid object.

The trial system by a unit transmitter emits ultrasonic waves on the side solid material. A solid body rotated every  multiple 20˚ of 0-180˚  to get an angle variations. The result obtained that  waves as 40 khz can detect the form of solid material defect. The form of defect in a solid material has  different wave pattern. Constant wave patterns with small amplitudo is a cylindrical material without defect, constant wave patterns with more much amplitudo is cylindrical material with cylindrical defect also and wave patterns whose amplitudo is different in any variation angle is cylindrical solid with cubicaly defect.


Keywords


ultrasonic, generator function, oscilloscope, transmitter, receiver, defect of solid materials

Full Text:

PDF


References

[1] Charles, H.,2003, Handbook of Non Destructive Evaluation, USA: Mcgraw-Hill Companies.

[2] Subiyanto, L. dan Sardjono, T., 2012, Deteksi Cacat Pada Material Baja Menggunakan Ultrasonik Non-Destructive Testing Dengan Metode Continuous Wavelet Transform, Seminar Nasional Teknologi Informasi Komunikasi Terapan, ITS, Surabaya.

[3] Ludwig, R. dan Roberti, D., 1989, A Nondestructive Ultrasonik Imaging Sistem for Detection of Flaws in Metal Blocks, IEEE Transactions On Instrumentation and Measurement Vol. 38 No. 1, Worcester.

[4] Sung, J., Furgason, E. dan Shin, Y., 1994, Surface Roughness Evaluation Via Ultrasonik Scanning, IEEE Transactions On Ultrasoniks, Ferroelectrics and Frequency Control Vol. 41 No. 6, West Lafayette, USA.



DOI: https://doi.org/10.22146/ijeis.10773

Article Metrics

Abstract views : 3030 | views : 4448

Refbacks

  • There are currently no refbacks.




Copyright (c) 2016 IJEIS - Indonesian Journal of Electronics and Instrumentation Systems

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.



Copyright of :
IJEIS (Indonesian Journal of Electronics and Instrumentations Systems)
ISSN 2088-3714 (print); ISSN 2460-7681 (online)
is a scientific journal the results of Electronics
and Instrumentations Systems
A publication of IndoCEISS.
Gedung S1 Ruang 416 FMIPA UGM, Sekip Utara, Yogyakarta 55281
Fax: +62274 555133
email:ijeis.mipa@ugm.ac.id | http://jurnal.ugm.ac.id/ijeis



View My Stats1
View My Stats2