Synthesis and Characterization of Polystyrene Sulfonic Acid from Expanded Polystyrene Foam as a Catalyst in the Synthesis of Triacetin

Renita Manurung; Rosdanelli Hasibuan; Fatimah Batubara; Handy Inarto; Alwi Gery Agustan Siregar; Auryn Saputra

doi:10.22146/ijc.60559

Synthesis and Characterization of Polystyrene Sulfonic Acid from Expanded Polystyrene Foam as a Catalyst in the Synthesis of Triacetin

https://doi.org/10.22146/ijc.60559

Renita Manurung⁽¹⁾, Rosdanelli Hasibuan⁽²⁾, Fatimah Batubara⁽³⁾, Handy Inarto^(4*), Alwi Gery Agustan Siregar⁽⁵⁾, Auryn Saputra⁽⁶⁾

(1) Department of Chemical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Jl. Almamater, Padang Bulan, Medan 20155, Indonesia
(2) Department of Chemical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Jl. Almamater, Padang Bulan, Medan 20155, Indonesia
(3) Department of Chemical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Jl. Almamater, Padang Bulan, Medan 20155, Indonesia
(4) Department of Chemical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Jl. Almamater, Padang Bulan, Medan 20155, Indonesia
(5) Department of Chemical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Jl. Almamater, Padang Bulan, Medan 20155, Indonesia
(6) Department of Chemical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Jl. Almamater, Padang Bulan, Medan 20155, Indonesia
(*) Corresponding Author

Abstract

In Indonesia, the composition of waste has gradually changed over time. To reduce expanded polystyrene (EPS) foam waste, we converted it into a heterogeneous acid catalyst, namely Polystyrene Sulfonic Acid (PSSA). The catalyst was then used in an esterification reaction to generate triacetin. In this research, the synthesis of PSSA was performed using a sulfonation reaction with silver sulfate (Ag₂SO₄) as the catalyst. Based on FTIR analysis, the sulfonation reaction was successful. The use of 0.5% and 1% catalysts led to a significant increase in the degree of sulfonation of PSSA, while there was a relatively constant increase when using 1.5–2.5% catalysts. The highest degree of sulfonation (78.63%) was achieved when the reaction was performed using 2% Ag₂SO₄ catalyst for 25 min. The PSSA with the highest degree of sulfonation was characterized using X-Ray Diffraction (XRD), SEM-EDX, and BET-BJH. This PSSA had a semi-crystalline structure with a crystallinity of 73.83%, a particle size of 1.75 nm, mesoporous pores with a radius of 16.984 Å, and a sulfur content of 15% (% mass).

Keywords

EPS foam; sulfonation; catalyst; silver sulfate; characterization

Full Text:

Full Text PDF

References

[1] Cordova, M.R., and Nurhati, I.S., 2019, Major sources and monthly variations in the release of land-derived marine debris from the Greater Jakarta area, Indonesia, Sci. Rep., 9 (1), 18730.

[2] Shah, J., Jan, M.R., and Adnan, 2014, Conversion of waste polystyrene through catalytic degradation into valuable products, Korean J. Chem. Eng., 31 (8), 1389–1398.

[3] Pourjafar, S., Kreft, J., Bilek, H., Kozliak, E., and Seames, W., 2018, Exploring large pore size alumina and silica-alumina based catalysts for decomposition of lignin, AIMS Energy, 6 (6), 993–1008.

[4] Martins, C.R., Ruggeri, G., and De Paoli, M.A., 2003, Synthesis in pilot plant scale and physical properties of sulfonated polystyrene, J. Braz. Chem. Soc., 14 (5), 797–802.

[5] Manurung, R., Anggreawan, M.D., and Siregar, A.G., 2020, Triacetin production using SiO₂–H₃PO₄ catalysts derived from bamboo leaf biomass waste for esterification reactions of glycerol and acetic acid, IOP Conf. Ser.: Mater. Sci. Eng., 801, 012052.

[6] Zhang, X., Zhao, Y., Xu, S., Yang, Y., Liu, J., Wei, Y., and Yang, Q., 2014, Polystyrene sulphonic acid resins with enhanced acid strength via macromolecular self-assembly within confined nanospace, Nat. Commun., 5 (1), 3170.

[7] Bozkurt, A., 2005, Anhydrous proton conductive polystyrene sulfonic acid membranes, Turk. J. Chem., 29 (2), 117–123.

[8] Carroll, W.R., and Eisenberg, H., 1966, Narrow molecular weight distribution poly(styrenesulfonic acid). Part I. Preparation, solution properties, and phase separation, J. Polym. Sci., Part A-2, 4 (4), 599–610.

[9] Chamack, M., Mahjoub, A.R., and Akbari, A., 2018, Zirconium-modified mesoporous silica as an efficient catalyst for the production of fuel additives from glycerol, Catal. Commun., 110, 1–4.

[10] Wang, Q., Lu, Y., and Li, N., 2016, Preparation, characterization and performance of sulfonated poly(styrene-ethylene/butylene-styrene) block copolymer membranes for water desalination by pervaporation, Desalination, 390, 33–46.

[11] Pirali-Hamedani, M., and Mehdipour-Ataei, S., 2017, Effect of sulfonation degree on molecular weight, thermal stability, and proton conductivity of poly(arylene ether sulfone)s membrane, Des. Monomers Polym., 20 (1), 54–65.

[12] Safronova, E.Y., Golubenko, D.V., Shevlyakova, N.V., D’yakova, M.G., Tverskoi, V.A., Dammak, L., Grande, D., and Yaroslavtsev, A.B., 2016, New cation-exchange membranes based on cross-linked sulfonated polystyrene and polyethylene for power generation systems, J. Membr. Sci., 515, 196–203.

[13] Groggins, P.H., 1958, Unit Process in Organic Chemistry, 5^th Ed., McGraw Hill, New York.

[14] Kučera, F., and Jančář, J., 1998, Homogeneous and heterogeneous sulfonation of polymers: A review, Polym. Eng. Sci., 38 (5), 783–792.

[15] Cheikh, R.B., Askeland, P.A., Schalek, R.L., and Drzal, L.T., 2002, Improving the adhesion properties of polypropylene using a liquid-phase sulfonation treatment, J. Adhes. Sci. Technol., 16 (12), 1651–1668.

[16] Wang, Y., Huang, J., Xia, X., and Peng, X., 2018, Fe–Co/sulfonated polystyrene as an efficient and selective catalyst in heterogeneous Baeyer–Villiger oxidation reaction of cyclic ketones, J. Saudi Chem. Soc., 22 (2), 129–135.

[17] Kausar, A., 2015, Fabrication and characteristics of poly(benzimidazole/fluoro/ether/siloxane/amide)/sulfonated polystyrene/silica nanoparticle-based proton exchange membranes doped with phosphoric acid, Int. J. Polym. Mater. Polym. Biomater., 64 (4), 184–191.

[18] Zhang, X., Zhang, L., and Yang, Q., 2014, Designed synthesis of sulfonated polystyrene/mesoporous silica hollow nanospheres as efficient solid acid catalysts, J. Mater. Chem. A, 2 (20), 7546–7554.

[19] Zaghaghi, Z., Mirzalili, B.B.F., and Monfared, A., 2019, Synthesis of 2,3-dihydroquinazolin-4(1H)-ones promoted by polystyrene sulfonic acid, Org. Chem. Res., 5, 80–86.

[20] Milla, I.M.N., Syahri, M.A., Wahyuni, E.T., Roto, R., and Siswanta, D., 2018, Modification of styrofoam waste as a low-cost adsorbent for removal of cadmium ion in aqueous solution, Orient. J. Phys. Sci., 3 (2), 127–142.

[21] Zou, X., Nie, X., Tan, Z., Shi, K., Wang, C., and Wang, Y., 2019, Synthesis of sulfonic acid functionalized zirconium poly(styrene-phenylvinyl phosphonate)-phosphate for heterogeneous epoxidation of soybean oil, Catalysts, 9 (9), 710.

[22] Jalal, N.M., Jabur, A.R., Hamza, M.S., and Allami, S., 2020, The effect of sulfonation reaction time on polystyrene electrospun membranes as polymer electrolyte, AIP Conf. Proc., 2290, 020049.

[23] Huang, Y., Wang, K., Dong, D., Li, D., Hill, M.R., Hill, A.J., and Wang, H., 2010, Synthesis of hierarchical porous zeolite NaY particles with controllable particle sizes, Microporous Mesoporous Mater., 127 (3), 167–175.

[24] Inoue, M., and Hirasawa, I., 2013, The relationship between crystal morphology and XRD peak intensity on CaSO₄·2H₂O, J. Cryst. Growth, 380, 169–175.

[25] Hindryawati, N., Maniam, G.P., Karim, M.R., and Chong, K.F., 2014, Transesterification of used cooking oil over alkali metal (Li, Na, K) supported rice husk silica as potential solid base catalyst, Eng. Sci. Technol. Int. J., 17 (2), 95–103.

[26] Roschat, W., Siritanon, T., Yoosuk, B., and Promarak, V., 2016, Rice husk-derived sodium silicate as a highly efficient and low-cost basic heterogeneous catalyst for biodiesel production, Energy Convers. Manage., 119, 453–462.

[27] Karnjanakom, S., Maneechakr, P., Samart, C., and Guan, G., 2018, Ultrasound-assisted acetylation of glycerol for triacetin production over green catalyst: A liquid biofuel candidate, Energy Convers. Manage., 173, 262–270.

[28] Setyaningsih, L.W.N., Rizkiyaningrum, U.M., and Andi, R., 2017, Pengaruh konsentrasi katalis dan reusability katalis pada sintesis triasetin dengan katalisator lewatit, Teknoin, 23 (1), 56–62.

[29] Yulvianti, M., Sobari, M.I., and Rijal, S., 2016, Optimaslisasi kinerja zeolit alam bayah sebagai katalis untuk pembuatan triacetin sebagai aditif premium, Teknika: Jurnal Sains dan Teknologi, 12 (1), 93.

DOI: https://doi.org/10.22146/ijc.60559