Kinetic Parameters Determination of Benzene Vapor Adsorption on Activated Carbon Using Differential Permeation Technique

https://doi.org/10.22146/ajche.50163

Aswati Mindaryani(1*), Boma W. Tyoso(2), Wahyudi B. Sediawan(3), Supranto Supranto(4)

(1) Chemical Engineering Department Gadjah Mada University Bulaksumur, Yogyakarta 55281 INDONESIA
(2) 
(3) 
(4) 
(*) Corresponding Author

Abstract


Equilibrium and kinetic data are very important for a reliable design of a large-scale adsorption system. The objective of the research was to determine the particle scale kinetic parameters of strongly adsorbed volatile organic compounds (VOCS)in activated carbon (AC) by using the differential permeation technique. The experimental rig consisted basically of upstream and downstream reservoirs separated by a slab-shaped AC that is 2 mm thick. After cleaning the slab overnight at 400 K and under vacuum condition, the experiment was started by opening the valve to allow vapor to diffuse through the AC. The upstream and downstream pressures were continuously recorded until equilibrium was reached. Another experiment was run by increasing incrementally the upstream pressure. The same experiment was carried out using nonadsorbed gas (argon) to estimate both Knudsen permeability and viscous permeability. The Knudsen, viscous, and surface diffusivities were determined by matching the total permeability against the experimental data. From the data obtained, it was found that both porosity and surface diffusivity change with loading. The surface diffusivity of benzene vapor in AC pores does not follow the Darken model, but it follows the hydrodynamic model of Gilliland, especially when the porosity is relatively constant at high loading. Keywords: Adsorption, benzene, differential permeation, kinetic, and volatile organic compounds (VOCs).

Keywords


Adsorption, benzene, differential permeation, kinetic, and volatile organic compounds (VOCs)

Full Text:

PDF


References

  1. Do, D.D. (1998). Adsorption analysis: Equilibria and kinetics, Imperial College Press, London.
  2. Do, D.D., and Wang, K. (1998a). “A new kinetic model for the description of adsorption kinetics in heterogeneous activated carbon," Carbon, 36, 1539.

  3. Do, D.D., and Wang, K. (1998b). “Dual diffusion and finite mass exchange model for adsorption kinetics in activated carbon," AICHE J., 44, 68.

  4. Gilliland, E., Baddour, R. F., Perkinson, G. P, and Sladek, K. J. (1974). "Diffusion on surfaces: Effect of concentration on the diffusivity of physically adsorbed gases," Ind Eng. Chem. Fundam, 13, 2, 99-100.

  5. Nguyen, C., and Do, D. D. (2000). "A dual Langmuir kinetic model for adsorption in carbon molecular sieve materials," Langmuir, 16, 1868.

  6. Prasetyo, I. (2000). Kinetics characterization of hydrocarbons on activated carbon with new constant molar flow and differential permeation techniques, Ph.D. Thesis, University of Queensland, Australia.

  7. Prasetyo, I., and Do, D. D. (1999). "Adsorption kinetics of light paraffins in activated carbon by a semi-batch constant molar flow rate method," A.J.Ch.E. Journal, 45, 8, 1892–1900.

  8. Prasetyo, 1., Do, H. D., and Do, D. D. (2002). "Surface diffusion of strong adsorbing vapors on porous carbon," Chemical Engineering Science, 57, 11-141.



DOI: https://doi.org/10.22146/ajche.50163

Article Metrics

Abstract views : 1408 | views : 862

Refbacks

  • There are currently no refbacks.


ASEAN Journal of Chemical Engineering  (print ISSN 1655-4418; online ISSN 2655-5409) is published by Chemical Engineering Department, Faculty of Engineering, Universitas Gadjah Mada.