Pengaruh Panjang Elektrode Sangkar Delta pada Nilai Resistans Pentanahan di Lokasi Sempit

  • Harnoko Stephanus Universitas Gadjah Mada
Keywords: pentanahan, batang pentanah, elektrode sangkar delta, resistans pentanahan

Abstract

Grounding rod is more practical than grounding plate or grounding strip. Grounding resistance value must be set as small as possible. But, it is hard to approach the standard grounding resistance value. There are some methods used to reduce grounding resistance like paralleling ground rod, extending ground rod, or enlarging ground rod diameter. This paper explains the effect of length variation of delta cage electrode (dimension of delta side is 1 meter) on single ground rod resistance value. In this paper, ground rod’s length and diameter are 1.5 meters and 10 millimeters respectively. Ground rod is planted on the ground while the but is on land surface. Grounding resistance value of that single ground rod then is being compared with grounding resistance value of the combination of single ground rod and the delta cage electrode (dimension of delta side is 1 meter). After this research, we can conclude that: (a) delta cage electrode (its side 1 m) with three edge rod (length 0.5 meters, 1 meter and 1.5 meters; diameter 10 millimeters) can minimize grounding resistance value of single ground rod (length 1.5 meters, diameter 10 millimeters) by 33 ohm, 45 ohm, dan 50 ohm; (b) delta cage electrode (its side 1 m) with six edge rod (length 0.5 meters, 1 meter, and 1.5 meters; diameter 10 millimeters) can minimize grounding resistance value of single ground rod (length 1.5 meters, diameter 10 millimeters) by 45 ohms, 52 ohms dan 56 ohms.

References

Panitia Revisi PUIL, Persyaratan Umum Instalasi Listrik Indonesia 2000, LIPI, Jakarta, 2000.

F. Haryanto Sumbung, ―Perlindungan Terhadap Sambaran Petir Peralatan Listrik dan Telekomunikasi dengan Pentanahan yang Disatukan dengan Menggunakan EMTP”, Tesis MSEE, Jurusan Teknik Elektro dan Teknologi Informasi, FT UGM, Yogyakarta, 2008.

T.S. Hutauruk, Pengetanahan Netral Sistem Tenaga dan Pengetanahan Peralatan, edisi ke 2, Penerbit Erlangga, Jakarta, 1991.

Switzer, Practical Guide to Electrical Grounding, ERICO Inc., Ohio, 1999.

Harnoko Stephanus, Pengaruh Elektrode Sangkar (Silindris) pada Nilai Resistans Pentanahan 1 Batang Pentanah di Lokasi Sempit, Laporan Penelitian Hibah JTETI FT UGM, 2013.

A.S. Pabla, Electric Power Distribution, Tata McGraw-Hill Education, New Delhi, 2004.

K. Pijpaert, ―Peraturan Umum untuk Elektrode Bumi dan Penghantar Bumi‖, Elektro Indonesia, No.24, tahun V, Januari, 1999.

Sri Lestari, Pengaruh Elektrode Sangkar Delta pada Nilai Resistans Pentanahan 1 Batang Pentanah di Lokasi Sempit, Laporan Penelitian Diploma Teknik Elektro SV UGM, 2013.

How to Cite
Harnoko Stephanus. (1). Pengaruh Panjang Elektrode Sangkar Delta pada Nilai Resistans Pentanahan di Lokasi Sempit. Jurnal Nasional Teknik Elektro Dan Teknologi Informasi, 5(2), 135-138. Retrieved from https://dev.journal.ugm.ac.id/v3/JNTETI/article/view/2959
Section
Articles