Removal Efficiency of Acid Red 18 Dye from Aqueous Solution Using Different Aluminium-Based Electrode Materials by Electrocoagulation Process

https://doi.org/10.22146/ijc.43206

Nurulhuda Amri(1), Ahmad Zuhairi Abdullah(2*), Suzylawati Ismail(3)

(1) Faculty of Chemical Engineering, Universiti Teknologi MARA (UiTM), Cawangan Pulau Pinang, 13500 Permatang Pauh, Penang, Malaysia
(2) School of Chemical Engineering, Universiti Sains Malaysia, Engineering Campus, 14300 Nibong Tebal, Penang, Malaysia
(3) School of Chemical Engineering, Universiti Sains Malaysia, Engineering Campus, 14300 Nibong Tebal, Penang, Malaysia
(*) Corresponding Author

Abstract


This work compares commercial aluminium electrode for use in the treatment of wastewater by electrocoagulation process against waste aluminium cans electrode. The applicability of the waste aluminium cans electrode was tested for decolorization of Acid Red 18 dye as a model pollutant. The batch electrocoagulation process using both types of electrode was conducted at a current density of 25 mA/cm2, a pH of 3, an initial concentration of 100 mg/L and 25 min of reaction time. The elemental composition and surface morphology of both electrode materials and the sludge produced were analyzed using SEM-EDX to establish the correlation between the properties and characteristics of both electrode materials with their dye removal performance. The results demonstrated that waste aluminium cans performed better than commercial aluminium electrode with a removal efficiency of 100% in 25 min of reaction time. This was due to the higher Al dissolution of waste aluminium cans electrode that contributed to the larger amount of Al3+ released into the solution to consequently form more flocs to remove the dye molecules. In conclusion, the proposed waste aluminium electrode was considered as efficient and cost-effective and had the potential to replace the conventional ones in treating colored industrial wastewater using electrocoagulation process.

Keywords


waste aluminium cans; commercial aluminium electrode; electrocoagulation process; Acid Red 18; removal efficiency

Full Text:

Full Text PDF


References

[1] Nogueira, F.G.E., Asencios, Y.J.O., Rodella, C.B., Porto, A.L.M., and Assaf, E.M., 2016, Alternative route for the synthesis of high surface-area η-Al2O3/Nb2O5 catalyst from aluminum waste, Mater. Chem. Phys., 184, 23–30.

[2] Marck Industries, Facts about Recycling Aluminum, 2015, https://www.marck.net/facts-about-recycling-aluminum/, accessed on 10 December 2018.

[3] Abdelrahman, E.A., 2018, Synthesis of zeolite nanostructures from waste aluminum cans for efficient removal of malachite green dye from aqueous media, J. Mol. Liq., 253, 72–82.

[4] Ahmedzeki, N.S., Hussein, S.J., and Abdulnabi, W.A., 2018, Synthesis of nano crystalline gamma alumina from waste cans, Iraqi J. Chem. Pet. Eng., 19 (1), 45–49.

[5] Hu, Y., Bakker, M.C.M., and de Heij, P.G., 2011, Recovery and distribution of incinerated aluminum packaging waste, Waste Manage., 31 (12), 2422–2430.

[6] Simanjuntak, W., Ginting, I., and Pandiangan, K.D., 2011, Removal of natural organic matter using electrocoagulation as a first step for desalination of brackish water, Indones. J. Chem., 11 (1), 103–107.

[7] Ensano, B.M.B., Borea, L., Naddeo, V., Belgiorno, V., de Luna, M.D.G., Balakrishnan, M., and Ballesteros, F.C., 2019, Applicability of the electrocoagulation process in treating real municipal wastewater containing pharmaceutical active compounds, J. Hazard. Mater., 361, 367–373.

[8] Dura, A., and Breslin, C.B., 2019, Electrocoagulation using aluminium anodes activated with Mg, In and Zn alloying elements, J. Hazard. Mater., 366, 39–45.

[9] Ghalwa, N.M.A., Saqer, A.M., and Farhat, N.B., 2016, Removal of Reactive Red 24 dye by clean electrocoagulation process using iron and aluminum electrodes, J. Chem. Eng. Process Technol., 7 (1), 1–7.

[10] Khosravi, R., Hazrati, S., and Fazlzadeh, M., 2016, Decolorization of AR18 dye solution by electrocoagulation: Sludge production and electrode loss in different current densities, Desalin. Water Treat., 57 (31), 14656–14664.

[11] Zhang, X.D., Hao, J.D., Li, W.S., Jin, H.J., Yang, J., Huang, Q.M., Lu, D.S., and Xu, H.K., 2009, Synergistic effect in treatment of C.I. Acid Red 2 by electrocoagulation and electrooxidation, J. Hazard. Mater., 170 (2-3), 883–887.

[12] El-Ashtoukhy, E.S.Z., and Amin, N.K., 2010, Removal of acid green dye 50 from wastewater by anodic oxidation and electrocoagulation-A comparative study, J. Hazard. Mater., 179 (1-3), 113–119.

[13] Khorram, A.G., and Fallah, N., 2018, Treatment of textile dyeing factory wastewater by electrocoagulation with low sludge settling time: Optimization of operating parameters by RSM, J. Environ. Chem. Eng., 6 (1), 635–642.

[14] Khandegar, V., and Saroha, A.K., 2013, Electrocoagulation for the treatment of textile industry effluent – A review, J. Environ. Manage., 128, 949–963.

[15] Azarian, G., Nematollahi, D., Rahmani, A.R., Godini, K., Bazdar, M., and Zolghadrnasab, H., 2014, Monopolar electro-coagulation process for azo dye C.I. Acid Red 18 removal from aqueous solutions, Avicenna J Environ. Health Eng., 1 (1), e354.

[16] Fajriati, I., Mudasir, and Wahyuni, E.T., 2019, Adsorption and photodegradation of cationic and anionic dyes by TiO2-chitosan nanocomposite, Indones. J. Chem., 19 (2), 441–453.

[17] Pang, Y.L., and Abdullah, A.Z., 2013, Current status of textile industry wastewater management and research progress in Malaysia: A review, Clean-Soil Air Water, 41, 751–764.

[18] Baban, A., Yediler, A., Avaz, G., and Hostede, S.S., 2010, Biological and oxidative treatment of cotton textile dye-bath effluents by fixed and fluidized bed reactors, Bioresour. Technol., 101 (4), 1147–1152.

[19] Ministry of Natural Resources and Environment Malaysia, 2010, Environmental Requirements : A Guide for Investors, 11th Ed., http://www.doe.gov.my/ eia/wp-content/uploads/2012/03/A-Guide-For-Investors1.pdf, accessed on 10 December 2018.

[20] Elabbas, S., Ouazzani, N., Mandi, L., Berrekhis, F., Perdicakis, M., Pontvianne, S., Pons, M.N., Lapicque, F., and Leclerc, J.P., 2016, Treatment of highly concentrated tannery wastewater using electrocoagulation: Influence of the quality of aluminium used for the electrode, J. Hazard. Mater., 319, 69–77.



DOI: https://doi.org/10.22146/ijc.43206

Article Metrics

Abstract views : 3091 | views : 2769


Copyright (c) 2019 Indonesian Journal of Chemistry

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

 


Indonesian Journal of Chemistry (ISSN 1411-9420 /e-ISSN 2460-1578) - Chemistry Department, Universitas Gadjah Mada, Indonesia.

Web
Analytics View The Statistics of Indones. J. Chem.